DIY Kitchen Company


Please rollover your mouse and click the kitchen component you would like to find out more about:


Base Cupboards

  • All our carcases are manufactured to YOUR specific size requirements and the sizes below are indicative only.
  • Base cupboards are nominally 900mm overall height - including kicker and allowing for a 33 mm bench tops.
  • All carcases are constructed in 16 mm highly moisture resistant particle board with hard wearing unchippable 1mm PVC edging.
  • All components are pre drilled ready for hinge plates and one adjustable shelf which makes assembley easy.
  • Each cabinet is individually labelled to save that frustrating sorting process.
  • All cupboard doors are fitted with Blum soft closing hinges.
  • Our standard base kickers are made with modern stainless steel look pre finished laminate. They clip on for easy installation and removal should the need arise.

Standard base cupboards
1 door units are available 250mm - 600mm wide
2 door units are available 600mm - 1100 mm wide

Corner base cupboards are nominally 900 x 900
These units are available with an adjustable shelf or lazy susan

^ BACK TO TOP


Standard Drawers

  • All drawers are metalsided with solid 16 mm bottoms. All top drawers have Blum premium quality soft closing mechanisms. These can be fitted to all drawers as an optional extra

Drawer options available:
Option One - 4 Equal Drawers
Option Two - 1 Cutlery Drawer & 2 Pot Drawers
Option Three - 1 x Microwave Opening and 1 x Deep Pot Drawer
Option Four - 3 X Equal Pot Drawers

Drawer banks are available in the following widths
400mm 500mm 600mm 750mm 800mm 900mm

All draws can be made soft closing at an additional cost.

^ BACK TO TOP


Our overhead cupboards are constructed in the same superior materials as the base cupboards. Our overheads can come in any size you required.

Standard Overhead Cupboards
Standard Depth 300 mm deep
Refrigerator Overhead 450 mm deep

Standard Heights
400mm, 600mm, 750mm & 900mm high

Standard Widths
Single door units 250mm - 600mm
Double door units 600mm - 1100mm
Corner Units 600mm - 600mm

Open shelf units come in the same sizes as above

Optional Extras
Glass doors 1 Pane of glass per door
4 Panes of glass per door

^ BACK TO TOP


Holes can be cut and provision for cabling can be routered to backs to allow for easy installation of halogen lights.

^ BACK TO TOP


Pantry cupboards are available as a standard wall cupboard or as a corner unit.

Usually pantry cupboards come with adjustable shelves with 1 fixed shelf at approx. 900mm high to give the unit greater structural strength.

Small ½ Pantry
These cupboards are made to sit on top of a set of pot drawers. This allows for easy access to the lower sections.

Medium Pantry Cupboards Approx 2150 high
Single door units 400mm - 600mm
Double door units 600mm - 600mm

Tall Pantry Cupboards Approx 2350 tall
Single door units 400mm - 600mm
Double door units 400mm - 600mm

Corner Pantry Units
Standard size 1000mm x 1000mm
Deluxe size 1100mm x 1100mm

^ BACK TO TOP


Wall oven modules with microwave 600mm wide
This unit comes with 2 x Pot drawers below, an allowance for a single wall oven and a recess for the microwave above and a 2 door overhead above.
Option :This would be the same unit if the oven had a griller and no microwave

Wall oven module NO microwave 600mm wide
This unit comes with 2 x Pot drawers below, an allowance for a single wall oven and a larger 2 door overhead above

Note: Wall oven modules require 2 x tall end panels either side

Underbench Oven 600w or 900 w
This base unit allows for an underbench oven and comes with a bottom filler to allow for your specific oven.

^ BACK TO TOP


Panels are required on exposed ends and fronts of your kitchen cupboards.

Most of the colours in the vinyl doors come in a matching Melamine finish which is usually used for the end panels as they are coloured both sides and are more economical than the vinyl end panels.

Tall end Panels are usually required either side of a refrigerator, wall oven or pantry

Base end panels are required to the ends of cupboards or to form a dishwaher opening

Overhead end panels are required on exposed ends of overheads and often either side of the rangehood

A front panel is required when the front of the cupboard is exposed ie on an island or peninsula kitchen

^ BACK TO TOP











HOME   |   FLAT PACK KITCHENS   |   GALLERY   |   KITCHEN DESIGN KIT   |   SEMINARS   |   DESIGN SERVICES   |   DIY ASSEMBLY INSTRUCTIONS   |   CONTACT

Kitchen Components Finishes and Selections How much will it cost? Free gift voucher